TeraPump - TREP03 - Multi-Purpose Electric Transfer Pump
"We were so tired of holding up gas containers that were soooo slow thanks to the anti spill features. This thing fills up some a zero turn tank in less than 2 minutes with very little effort. We do have the container up on a shelf which i think helps tremendously. It has turned that corner of the outdoor shed into our little gas stations. We have used it for diesel a few times we just make sure all the gas has drained out of it before swapping it over. We use a small sla battery to power it and we rarely have to charge it, in fact i don’t think we have charged it this summer so it must not draw much current." - Allan J.
INTRODUCING: The TERAPUMP TREP03
''YOU CONTROL THE FLOW...''
Pump 2.8 Gallons of Fuel or Liquid Per Minute
8 Ft Hose
Want More Power?...
Need to transfer a lot of fuel or liquids in a hurry?
The Tera Pump TREP03 gives you the power you need to transfer a variety of liquids in just a few minutes.
The TREP03 pumps 2.8 Gallons Per Minute...
- Powered By DC Clips & AC/DC Power Pack provides extra pumping power.
- Multi-Purpose not only can you transfer fuel but you can use the TREP03 with a variety of liquids.
- Flow Control Handle allows you to control the flow...
The TREP03 prevents you from lifting heavy gas cans, messy spills, and back strains.
ABOUT THE TERAPUMP TREP03
The TERA PUMP TREP03 is an affordable BATTERY OPERATED fuel transfer pump designed for quick and easy emptying of gas cans and containers of various sizes.
The TREP03 eliminates wasting fuel and the need to lift large, heavy, gas cans.
TRANSFER FUEL TO:
✔️ Lawn Mowers
✔️ Tractors / Heavy Equipment
✔️ Snow Blowers / Snow Throwers
✔️ Snow Mobiles
✔️ Jet Ski's
✔️ Fuel Powered Generators
✔️ Water (NOT for Drinking Water)
✔️ Light Oils
✔️ Chemical Insecticides
✔️ Mild Acids
❌ NOT COMPATIBLE WITH:
Drinkable Liquids, Thinners, Solvents,
Hot Liquids, Aceton, Benzen, Creosol, Ethyl, Phenol, Methylethyl, Concentrated Caustic Soda Liquid, Nitric Acid, Hydrochloric Acid, Sulfuric Acid, etc.
✔️ Power Adaptor
✔️ DC Clips
✔️ Filter Attachment
✔️ Shower Head Nozzle
✔️ Instruction Manual
How To Operate:
Step 1: Immerse the suction end of the pump into the container where the liquid is located (ex. Gas Can)
Step 2: Insert the tube into a container to receive the liquid.
Step 3: Turn the pump on.
*Caution: Do Not over fill the container. Avoid pumping liquid to a container higher than the pump's motor housing
Step 4: When finished, keep the pump upright and lift the handle above the pump mechanism to drain any liquid back into the original container.
*Do Not lay pump down until all liquid has been drained from the tube and pump.
Step 5: Run water through the pump after using it with any other liquid.
This will rinse the pump interior and extend the life of the pump.
*Gas Can Not Included*